Welcome to Maniac Performance!
1" X 3" Aluminium Metallic Heat Shield Thermal Sleeve
Heat Shroud is made from a high temperature rated glass fiber fabric with an aluminized outer facing. Same as Heat Sheath but with the added convenience of hook & loop closure design along the open edges. Without the need of removing one end of connected wires, cables and hoses, simply wrap Heat Shroud around whatever needs protection and close edges.
Super handy for those hard to reach Oil hoses close to your exhaust and manifold, without needing to remove the hose itself!
Available in multiple lengths and diameters to fit: wiring, fuel lines, brake lines, intake tubes, pipes, spark plug wires, battery cables, A/C hoses, and more.
Rated for Moderate Heat:
Not recommended for use on or against headers, exhaust pipes or extremely hot surfaces (The melting point of the Velcro fastener is about 162Cº) Can be used in about 90% of the underhood area when installed.
For best results seal the sleeves at each end with adhesive foil tape, shrink tube or stainless steel cable ties. Sleeves are conductive always insulate electric terminals that it might come in contact with sleeves. To ensure a proper fit, allow extra room for bends (for example: a 90º bend in a 3/4" tube will NOT fit in 3/4" I.D. Sleeve, In this case you would need 1" I.D. or higher)
Could be Suitable for all cars with an high performance needs like Nissan Skyline GTR, Laurel, Silvia s13, s14, s15, 200sx, 180sx, 240sx Mitsubishi Evo 1, 2 ,3, 4, 5, 6, 7, 8, 9, X, Mirage, Subaru WRX STI, Forester, b4, legacy, Honda Integra Type R, B18C, b16b, Civic Type R, Accord Euro R, Torneo, Celica Gt Four and other models like those.
Make sure to check our other listings!